新聞資訊
δ相時效態GH4169合金的熱加工行為
發布人：上海艾荔艾金屬材料有限公司www.jshcn.cn
更新時間：2015-10-31
采用熱模擬試驗機研究δ相時效態GH4169合金在變形溫度為980~1100 ℃、應變速率為1×10-3~1s-1條件下的熱壓縮變形行為，繪制真應力-真應變曲線。
δ相時效態GH4169合金的熱加工行為Hot working behavior of delta-processed GH4169 alloy
采用熱模擬試驗機研究δ相時效態GH4169合金在變形溫度為980~1100 ℃、應變速率為1×10-3~1s-1條件下的熱壓縮變形行為，繪制真應力-真應變曲線。結果表明：該合金在變形過程中出現了明顯的動態軟化行為。利用摩擦修正后的峰值應力數據構建了該合金的熱壓縮本構方程，獲得了本構方程材料常數分別為α=0.005626、n=4.2643、A=5.6185×1017、Q=486.8 kJ/mol。構建了不同應變量ε下合金本構方程材料常數的五次多項式組，并根據多項式對其流變應力進行了預測。結果表明其預測數據與摩擦修正數據基本相符。利用動態材料模型方法建立了該合金在不同應變量下的熱加工圖，分析了其在不同變形條件下的動態再結晶特性及流變失穩行為。
The hot compressive deformation behavior of delta-processed GH4169 alloy was investigated at temperature range of 980-1100 ℃ with strain rate from 1×10-3?to 1 s-1by thermal simulator. The true stress-true strain curves were obtained. The results show that the apparent dynamic softening behaviors occur during deformation. By using the friction-corrected peak stress data, the constitutive equation of the alloy for hot compression was established. The material constants are obtained to beα=0.005626, n=4.2643, A=5.6185×1017, Q=486.8 kJ/mol, respectively. A group of five-order polynomials showing the relationship between material constants of the constitutive equation and the strain was constructed, by which the flow stress was predicted. The predicted data are in good agreement with the friction-corrected one.According to the methods of dynamic material model, the hot processing maps of the alloy at different strains were established. The dynamic recrystallized characteristic under different deformation conditions and the flow instability behavior were also analyzed.
以上資料由上海艾荔艾金屬材料有限公司提供，歡迎新老客戶來電洽購。
本文來自上海艾荔艾金屬材料有限公司http://www.jshcn.cn，轉載請注明出處。
前一頁：粉末冶金高溫合金FGH96的熱加工圖及熱壓縮變形過程的開裂行為
后一頁：00Cr16Sn超純鐵素體不銹鋼焊接接頭腐蝕性能