新聞資訊
Al-Cu-Li-Mg-Mn-Zn-Ag合金的熱變形流變行為與本構方程
發布人：上海艾荔艾金屬材料有限公司www.jshcn.cn
更新時間：2015-09-16
采用等溫熱壓縮測試和TEM分析研究鋁鋰合金的流變行為與組織演化規律。
Al-Cu-Li-Mg-Mn-Zn-Ag合金的熱變形流變行為與本構方程Flow behavior and constitutive equations of Al-Cu-Li-Mg-Mn-Zn-Ag alloy during isothermal compression
采用等溫熱壓縮測試和TEM分析研究鋁鋰合金的流變行為與組織演化規律。結果表明：合金的熱塑性變形過程受熱激活控制，當變形溫度低于410 ℃時，流變曲線具有明顯的峰值應力，曲線由加工硬化、動態軟化和穩定階段3個階段組成；當變形溫度高于410 ℃后，峰值應力不明顯。隨應變量的增加，合金組織演化規律為產生大量無規則纏結位錯→“多邊化”形成“位錯墻”→分割原始晶粒成若干亞晶→亞晶合并長大并同時經受變形→重復上述過程。應變量的增加導致大量空位產生，刃型位錯更易攀移、重組和對消，晶內形成亞晶組織。求解得到合金的材料常數如下：結構因子A為2.787×1016；變形激活能Q為217.397 kJ/mol；應力指數n為6.11656；應力水平參數α為0.012568 mm2/N。應變速率和溫度對合金流變應力的影響可以用包含Arrhenius等式的Z參數表示。
The flow behavior and microstructure evolution of Al-Li alloy were investigated by isothermal compression tests and TEM analysis. The results show that the hot plastic deformation of the alloy is heat activation process. The flow curve consists of work hardening, dynamic softening and stabilization stage, and it has obvious peak stress when the deformation temperature is below 410 ℃. Otherwise, when the deformation temperature is above 410 ℃, the peak stress is not obvious. The microstructure evolution of the test alloy experiences irregular dislocation tangles→polygonization forming dislocation walls→segmentation of the original grain into several subgrains→the coalescence and growth of subgrains undergoing deformation→repeating the above process with increasing the strains. And increasing the strain causing the increase in the number of vacancies, leading to edge dislocation easier to climb, rearrangement and annihilation and formation of subgrains in intragranular. The constants of alloy material are obtained as follows: structure factor A of 2.787×1016, deformation activation energy Q of 217.397 kJ/mol, stress exponent n of 6.11656, stress level parameter α of 0.012568 mm2/N. The effects of strain rate and temperature on the hot deformation behavior were represented by Zener-Hollomon parameter including Arrhenius term.
以上資料由上海艾荔艾金屬材料有限公司提供，歡迎新老客戶來電洽購。
本文來自上海艾荔艾金屬材料有限公司http://www.jshcn.cn，轉載請注明出處。