新聞資訊
β固溶處理對TC21合金組織性能的影響
發布人：上海艾荔艾金屬材料有限公司www.jshcn.cn
更新時間：2015-09-11
對等軸組織TC21合金進行β相區高溫固溶+α/β相區低溫固溶+低溫時效熱處理；分析β相區高溫固溶冷卻速率、α/β相區低溫固溶溫度對TC21合金組織和性能的影響。
β固溶處理對TC21合金組織性能的影響Effect of β solution treatment on morphology and mechanical properties of TC21 alloy
對等軸組織TC21合金進行β相區高溫固溶+α/β相區低溫固溶+低溫時效熱處理；分析β相區高溫固溶冷卻速率、α/β相區低溫固溶溫度對TC21合金組織和性能的影響。結果表明：隨著β相區固溶冷卻速率的增加，α/β相區固溶熱處理后合金中條狀α相尺寸明顯減小，α條厚度減小；隨著α/β區固溶處理溫度的降低，在相同的β相區固溶冷卻速率下，合金中的初生條狀初生α相尺寸有一定的減小，相含量增加。經過(960 °C, 1 h, FC)+ (890 °C, 1 h, AC)+(620 °C, 6 h, AC)三重熱處理后，TC21合金的強度、塑性和韌性匹配較好。這表明三重熱處理可以改善常規鍛造TC21合金的綜合力學性能。
The equiaxed TC21 alloy samples were β solution treated, followed by α/β solution treatment and then aged at low temperature. The effect of β heat treatment cooling rate and temperature of α/β heat treatment on the morphology of TC21 alloy was analyzed. The results show that higher cooling rate of β heat treatment leads to the shrinking of platelet α phase, in the α/β heat treatment process. It is also confirmed that lower α/β heat treatment temperature, after the same beta heat treatment process, results in the decrease of width and increase of the content of platelet α phase. After optimized triplex heat treatment (960 °C, 1 h, FC)+(890 °C, 1 h, AC)+(620 °C, 6 h, AC), the strength, plasticity and fracture toughness match well, indicating that the triplex heat treatment can improve the synthetical mechanical properties of TC21 alloy.
以上資料由上海艾荔艾金屬材料有限公司提供，歡迎新老客戶來電洽購。
本文來自上海艾荔艾金屬材料有限公司http://www.jshcn.cn，轉載請注明出處。