新聞資訊
Ti-1100高溫鈦合金與氧化釔陶瓷型殼間的界面反應
發布人：上海艾荔艾金屬材料有限公司www.jshcn.cn
更新時間：2015-08-29
采用延長界面反應時間的方法，通過SEM、OM、EDS、XRD等分析測試手段，研究了Ti-1100高溫鈦合金與氧化釔型殼間的界面反應。
Ti-1100高溫鈦合金與氧化釔陶瓷型殼間的界面反應Interfacial reaction between high-temperature titanium alloy
Ti-1100 and Y2O3 ceramic mold
采用延長界面反應時間的方法，通過SEM、OM、EDS、XRD等分析測試手段，研究了Ti-1100高溫鈦合金與氧化釔型殼間的界面反應。結果表明：在本實驗條件下，Ti-1100合金熔體與氧化釔型殼間的界面比較平整，沒有看到明顯的界面反應層存在；界面處的相組成主要為α-Ti和Y2O3；從界面處向合金基體內組織比較均勻，由細小的針狀α板條和部分粗大塊狀α構成，基體內分布有小的氧化釔顆粒。
The interfacial reaction between high-temperature
titanium alloy Ti-1100 and Y2O3 ceramic mold was studied
through prolonging reaction time. The morphologies and microstructures of
interface were analyzed by XRD, OM and SEM/EDS. The results show that the
interface between high-temperature titanium alloy Ti-1100 and
Y2O3 ceramic mold is flat, wihout any significant reaction
layer. The α-Ti and Y2O3 phase are found on the interface.
The microstructures from the interface to base alloy are homogeneous, consisting
of fine needle α phase and massive α phase. Also, some fine
Y2O3 particles are found in the base alloy.
以上資料由上海艾荔艾金屬材料有限公司提供，歡迎新老客戶來電洽購。
本文來自上海艾荔艾金屬材料有限公司http://www.jshcn.cn，轉載請注明出處。